Processing/Storage Cabinet Four-Cord 30A Three-Phase Delta with Splash-Proof Power Plugs and Receptacles - Data Warehouse Appliances

2700 Platform Product and Site Preparation Guide

Product
Data Warehouse Appliances
Published
March 2018
Language
English (United States)
Last Update
2018-04-18
dita:mapPath
yop1471886638949.ditamap
dita:ditavalPath
2700.ditaval.ditaval
dita:id
zqx1471648424914
Product Category
Hardware

This plug type is for Canada, Columbia, El Salvador, Japan, Mexico, Nicaragua, Panama, South Korea, Taiwan, United States, and Venezuela. a

Unit
  • 2700 Cabinet
Power Type

30A three-phase Delta power

Nameplate Rating b c
  • 24A per cord
  • 200-240V~, 3+PE

Expected Utility Power Sources

(Provided by Site)

  • Three-phase Wye with a line-to-neutral voltage typically 120V or 127V and a line-to-line voltage of 200V to 240V.
  • Alternate expected power source (Japan): Delta power source 200V to 240V on each side.
With either of these two utility power sources, each of the 4-pin power plugs will connect to all three lines and also to safety ground. With this power solution the power plug will not have a neutral connection.

Power Plug and Number of Cords

(Supplied with Product)

IEC 60309 CEE17, pin and sleeve, 30A, Blue (3Ø250V), 3P4W, with 9-hour keying, IP44 splash-proof plug

(Walther Electric brand is shown below. Actual brand supplied with cabinet may vary.)


Four AC feeder box cords per cabinet, top or bottom egress.

The minimum bend radius limit for the power cord is 10.9 cm (4.3 in.). Do not bend the power cord tighter than this limit.

AC Feeder Box Power Cord Connections to Site Power

(For Redundancy)

The cabinet contains two AC feeder boxes on the left side of the cabinet and two AC feeder boxes on the right side of the cabinet. Each AC feeder box has one power cord (four total). The two power cords on the left side of the cabinet connect to one site power source. The two power cords on the right side of the cabinet connect to the second site power source.

Power Receptacle or Connector

and

Circuit Breakers

(Provided by Site)

IEC 60309 CEE17, pin and sleeve, 30A, Blue (3Ø250V), 3P4W, with 9-hour keying, IP44 splash-proof connector or receptacle



Example receptacles (similar products are available from other companies):
  • Scame Electrical Solutions SCM430R9S (shown above)
  • Walther Electric 430409


Example connectors for use with cordage (similar products are available from other companies):
  • PC Electric 2249-9
  • Scame Electrical Solutions SCM430C9S
  • Walther Electric 330409 (shown above)
  • Walther Electric 332409
Example connector for use with 1-inch NPT fitting for connection to conduit: d
  • Walther Electric PG29-100 combined with Walther Electric 332409
Example connector for use with 1 ¼-inch NPT fitting for connection to conduit: d
  • Walther Electric PG29-125 combined with Walther Electric 332409

Customer to supply four receptacles or connectors per cabinet. e

One three-pole site circuit breaker required for each power cord; customer must provide required site circuit breakers.

a Bahrain, Brazil, Lebanon, Philippines, and Saudi Arabia require discussions with the site team to determine the appropriate power feature for the specific site.

b Do not use this table to determine power consumption, to estimate current draw, or to estimate heat generation. For these parameters, see Site Environmental Planning. Nameplate ratings are a statement of product certification.

c Frequency rating is 50 or 60 Hz for all products.

d Conduit Adapters do not connect to the ground terminal of the connector. Consult your local code grounding requirements before using adapters.

e Customer can obtain connectors from any source. Connectors are available from Teradata by ordering kit 2021-K901. Two kits are required per processing/storage cabinet.

For input power plugs and receptacles for Platform Framework Cabinets, see the Teradata Platform Framework Cabinet Model 12 Hardware Service Guide, B035-5389.