16.20 - Example Display - IBM CICS Interface for Teradata

IBM CICS Interface for Teradata® Reference

prodname
IBM CICS Interface for Teradata
vrm_release
16.20
created_date
October 2018
category
Programming Reference
featnum
B035-2448-106K

Below is an example of the display the DSES transaction produces. Leading zeros have been suppressed.

Teradata Database--CICS SESSION CROSS REFERENCE DISPLAY

TRAN TASK# TERM TDP SESS# REQUEST# FUNCTION STA IBUSZ  OBUSZ #START #CONT

H331  123  1A4B  0  1012      298  CONNECT  INC  1024   1024     0     0
H331  125  1A4D  0  1014     3122  STARTREQ INC  1024   1024     2     0
HICE  129        0  1022     3i55  STARTREQ INC  1024   1024     5    11

The headings in the example are defined as follows:

Heading Definition
TRAN The CICS transaction ID of the last transaction that issued a request on this session
TASK# The CICS task ID number of the last transaction that issued a request on the session
TERM The terminal ID that owns the session if the transaction is started from a terminal. This field contains blanks if the transaction is not started from a terminal
TDP The TDPID of the TDP through which the transaction has established the Teradata session
SESS# The number of the Teradata session (in decimal)
REQUEST# The number of the last Teradata request (in decimal)
FUNCTION The last CLI function that was issued on this session
STA The status of the last request issued on this session, including CMP (complete) or INC (incomplete)
IBUSZ The size (in bytes) of the application’s fetch buffer
OBUSZ The size (in bytes) of the application’s request buffer
#START The count of all Teradata start requests initiated on the session
#CONT The count of all Teradata continue requests issued on the session

DSES uses Basic Mapping Support (BMS) paging. This enables the operator to page through the DSES output using BMS paging commands.

Teradata recommends that the terminals from which operators issue the DSES transid are defined to CICS with Automatic Transaction Initiation (ATI) so that after invoking DSES, the CICS paging facility can display the first output page.

If the DSES output does not fit on one screen, you can display additional screens by using the CICS operator paging commands. Normal CICS paging conventions apply.