Purpose
The SHOW CLUSTER command displays all AMPs in a specified cluster for the current or new configuration map.
Syntax
- CN = nnnn
- the cluster number for which the appropriate AMPs are to be displayed.
- FROM or F
- Use this to specify the map that contains the information you want
to list:
- CURRENT or C is the current configuration map. This is the default if you do not specify FROM or F.
- NEW or N is the new configuration map, which will be in effect only after you run the Reconfiguration utility.
- mapname or mapnumber identifies a contiguous map.
Example: To display all AMPs in a specified cluster
To display the current configuration map for cluster three and its associated AMPs, type:
show cluster cn = 3
An example output generated by the SHOW CLUSTER command is shown below.
OK, AMPs of cluster 3 are listed. Vproc Status Cluster Vproc Status Cluster ______ _______ ________ ______ _______ _________ 3 Online 3 7 Online 3 11 Online 3 15 Online 3