Type B Power: Appliance Cabinet Four-Cord 30A Three-Phase Delta with Watertight Power Plugs and Receptacles

Type B Power: Appliance Cabinet Four-Cord 30A Three-Phase Delta with Watertight Power Plugs and Receptacles - Appliance for Hadoop

Appliance for Hadoop 6 Platform Product and Site Preparation Guide

Product

Appliance for Hadoop

Published

February 2018

Language

English (United States)

Last Update

2018-04-13

dita:mapPath

cwt1471885643827.ditamap

dita:ditavalPath

hadoop6.ditaval.ditaval

dita:id

ikf1471650918043

Product Category

Hardware

This plug type is for Canada, Columbia, El Salvador, Japan, Mexico, Nicaragua, Panama, South Korea, Taiwan, United States, and Venezuela. a

Unit	Appliance for Hadoop 6 Cabinet
Power Type	30A three-phase Delta power
Nameplate Rating b c	24A per cord 200-240V~, 3+PE
Expected Utility Power Sources (Provided by Site)	Three-phase Wye with a line-to-neutral voltage typically 120V or 127V and a line-to-line voltage of 200V to 240V. Alternate expected power source (Japan): Delta power source 200V to 240V on each side. With either of these two utility power sources, each of the 4-pin power plugs will connect to all three lines and also to safety ground. With this power solution the power plug will not have a neutral connection.
Power Plug and Number of Cords (Supplied with Product)	IEC 60309 CEE17, pin and sleeve, 30A, Blue (3Ø250V), 3P4W, with 9-hour keying, IP67 watertight plug (Walther Electric brand is shown below. Actual brand supplied with cabinet may vary.) Four AC feeder box cords per cabinet, top or bottom egress. The minimum bend radius limit for the power cord is 10.9 cm (4.3 in.). Do not bend the power cord tighter than this limit.
AC Feeder Box Power Cord Connections to Site Power (For Redundancy)	The cabinet contains two AC feeder boxes on the left side of the cabinet and two AC feeder boxes on the right side of the cabinet. Each AC feeder box has one power cord (four total). The two power cords on the left side of the cabinet connect to one site power source. The two power cords on the right side of the cabinet connect to the second site power source.
Power Receptacle or Connector and Circuit Breakers (Provided by Site)	IEC 60309 CEE17, pin and sleeve, 30A, Blue (3Ø250V), 3P4W, with 9-hour keying, IP67 watertight connector or receptacle Example receptacles (similar products are available from other companies): Hubbell HBL430R9W Leviton 430R9W Russellstoll ABB430R9W Scame Electrical Solutions SCM430R9W Walther Electric 439409 (shown above) Example connectors for use with cordage (similar products are available from other companies): Hubbell HBL430C9W Leviton 430C9W Russellstoll ABB430C9W Scame SCM430C9W Walther Electric 338409 (shown above) Example connectors for use with ¾-inch NPT fitting for connection to conduit: d Hubbell HBL430R9W combined with Hubbell SAB34 or Leviton 430C9W combined with Leviton SAB34 Example connector for use with 1-inch NPT fitting for connection to conduit:d Walther Electric PG29-100 combined with Walther Electric 338409 Customer to supply four receptacles or connectors per cabinet. e One three-pole site circuit breaker required for each power cord; customer must provide required site circuit breakers.
a Bahrain, Brazil, Lebanon, Philippines, and Saudi Arabia require discussions with the site team to determine the appropriate power feature for the specific site. b Do not use this table to determine power consumption, to estimate current draw, or to estimate heat generation. For these parameters, see Site Environmental Planning. Nameplate ratings are a statement of product certification. c Frequency rating is 50 or 60 Hz for all products. d Conduit Adapters do not connect to the ground terminal of the connector. Consult your local code grounding requirements before using adapters. e Customer can obtain connectors from any source. Connectors are available from Teradata by ordering kit 2021-K904. Two kits are required per appliance cabinet.