Preparing for the Procedure - Aster Appliances

Data loss and/or warranty violation may occur if this procedure is not strictly followed. Accessing or initiating other replacement procedures may cause data loss and loss of warranty coverage.

Wear an anti-static wrist strap attached to an unpainted metal surface on the rack or chassis when handling parts.

Only trained customer personnel should perform this procedure.

If necessary, log on to https://access.teradata.com and initiate an incident.
Obtain a replacement part as described in Obtaining a Replacement Part.
Contact the system administrator if you do not know the host name or IP address of the designated host CMIC (SMWeb 12.06 and later) or SOV-enabled CMIC (SMWeb 12.05 and earlier).
In SMWeb 12.05 and earlier, you must access the home page of a CMIC that is SOV-enabled. If the CMIC is not SOV-enabled, most web applications and pages are unavailable. If this occurs, you must navigate to the SMWeb home page of an SOV-enabled CMIC. For more information about the SMWeb home page, see SMWeb online help or the Teradata Server Management Web Services User Guide (B035-5350) available at http://www.info.teradata.com.
Remove the new part from its packaging and place it on a static-free surface.
Record the serial number and/or part number of the new part in the site equipment log.

Using a browser, connect to the Server Management Web Services home page by typing the following in the Address field of the browser:

CMIC Version	Home Page Address
SMWeb 12.06 and later:	http://<hostname or IP address of CMIC or Teradata ServiceConnect connection>:9981/CWA/home.asp
SMWeb 12.05 and earlier:	http://<hostname or IP address of SOV-enabled CMIC>:9980/CWA/home.asp

On the Server Management Web Services home page, click Server Management Client.
If prompted, log on to Server Management Client as a Service User. The Server Management Client software opens.
If you have a multi-system configuration, in the Server Management Client Tree View, in the System pull-down menu, select All.
Identify the node containing the failed power supply:
1. In the Server Management Client window, click the Summary Alerts tab.
2. In the Summary Alerts tab, select the alert summary.
3. Click Locate Components. Server Management highlights the affected component in the Tree View.
Open a maintenance window:
1. With the targeted node highlighted, select Functions > Maintenance Window.
2. In the Name field, enter a name for the maintenance window.
3. In the Length of Maintenance, either accept the default of four hours or set the Start Time and End Time.
4. Click Activate.
5. In the Information dialog box, click Close.
If more time is needed to complete the procedure, extend the duration of the open maintenance window by changing the number of hours in the Length of Maintenance field and clicking Update.
In the Tree View, click the affected node to highlight it.
Select Functions > Replace FRU.
When the Replace FRU dialog box appears, select Chassis Component, then click OK. The Node window appears.
If necessary, click the tab with a indicating the location of the failed node power supply.
Node Rear View with a Red Icon Indicating a Failed Power Supply
Select the numbered red icon identifying the failed power supply.
Verify that the node power supply is ready for servicing.
Node Power Supply Replace Procedure
In the FRU Replace window, click OK. The software checks the power supply status and verifies that all conditions for replacing the power supply have been met.
If any problems are encountered, notify Teradata Customer Support. Use a contact method that is in accordance with your service contract. If your system is not set up with Automatic Incident Creation (AIC), log on to https://access.teradata.com and initiate or update an incident. If your system is set up with AIC, close the maintenance window and add a comment.
Click OK to enable the chassis locator LED.