The command line interface provides an alternate method for configuring SNMP. Use the following procedure if the Data Domain webpage is not available.
- Access the Data Domain CLI connection.
- At the command prompt, type snmp add trap-host <CMIC IP Address>:162 to add the SNMP trap hosts.
- Confirm the addition.
- At the command prompt, type snmp add ro-community public to add the public community with read-only access.
- Confirm the addition.
- At the command prompt, type snmp add rw-community private to add the private community with read-write access.
- Confirm the addition.
- At the command prompt, type snmp enable to enable SNMP.
Refer to the following example.
sysadmin@# snmp add trap-host 153.64.104.77:162
SNMP v2c Trap Hosts:
--------------------
Trap Host Port Community
------------- ---- ---------
153.64.104.77 162
------------- ---- ---------
SNMP v3 Trap Hosts:
-------------------
Trap Host Port User
--------- ---- ----
--------- ---- ----
# snmp add ro-community public
Community strings such as 'public' or 'private' are well-known and insecure.
Confirm addition? (yes|no) [no]: yes
Communities or hosts already exist
The object already exists
sysadmin@barp-dd6900-2# snmp add rw-community private
Community strings such as 'public' or 'private' are well-known and insecure.
Confirm addition? (yes|no) [no]: yes
Communities or hosts already exists
The object already exists