Stop a Job | Teradata Data Mover - 17.11 - Stopping a Job - Teradata Data Mover

Teradata® Data Mover User Guide

Product
Teradata Data Mover
Release Number
17.11
Release Date
October 2021
Content Type
User Guide
Publication ID
B035-4101-091K
Language
English (United States)
Use the stop command to stop a Data Mover job after the job has been started.
  1. Type datamove stop -job_name PayableJob1 on the command line, where PayableJob1 is the name of the job.
    The job status is set to USER CANCELLED. Agents are allowed to finish the job tasks already in progress, so that work on the job can continue after running the stop command. If the job was performing its final tasks, the job might complete. This allows the job to stop as cleanly as possible.
  2. Once the job has stopped do one of the following:
    Option Description
    Clean up the job using the cleanup command. Release locks on the source and target system, and remove any temp tables or error tables (if created by the job).
    Start the job again from the beginning using the start command. Restarts the job.