Run a Diagnostic Check on a Connector | QueryGrid - Running a Connector Diagnostic Check - Teradata QueryGrid

QueryGridâ„¢ Installation and User Guide - 3.06

Deployment
VantageCloud
VantageCore
Edition
Enterprise
IntelliFlex
Lake
VMware
Product
Teradata QueryGrid
Release Number
3.06
Published
December 2024
ft:locale
en-US
ft:lastEdition
2024-12-07
dita:mapPath
ndp1726122159943.ditamap
dita:ditavalPath
ft:empty
dita:id
lxg1591800469257
Product Category
Analytical Ecosystem

Run a diagnostic check on a connector to determine whether a target connector is available and can access the target system using the specified connector properties.

  1. Under Fabric Configuration, select Fabrics.
  2. On the Connectors tab, select "" next to the applicable connector and select Diagnostic Check.
  3. To test the connector and the associated fabric, select one of the following:
    • Active
    • Pending
    Any required properties that need configuring appear.
  4. If applicable, set the values for the connector properties.
  5. Select Run.
    The test results display in the Connector Diagnostic Check window.

    For more information, see Connector Diagnostic Check Metrics.