Run a Diagnostic Check on Links | QueryGrid - Running a Link Diagnostic Check - Teradata QueryGrid

QueryGridâ„¢ Installation and User Guide - 3.06

Deployment
VantageCloud
VantageCore
Edition
Enterprise
IntelliFlex
Lake
VMware
Product
Teradata QueryGrid
Release Number
3.06
Published
December 2024
ft:locale
en-US
ft:lastEdition
2024-12-07
dita:mapPath
ndp1726122159943.ditamap
dita:ditavalPath
ft:empty
dita:id
lxg1591800469257
Product Category
Analytical Ecosystem
Run a link diagnostic check to test the fabric connectivity between all nodes of the initiating and target systems, based on the communication policy associated with the link. The check reports either pass or fail. If the link diagnostic check fails, the report states why it failed. This check does not test connector configuration.
  1. Under Fabric Configuration, select Fabrics.
  2. On the Links tab, select "" next to the applicable link and select Diagnostic Check.
  3. To test the link, select one of the following:
    • Active
    • Pending
  4. Select Run.
    The test results display in the Link Diagnostic Check window.