Verify Failover Configuration | Teradata Data Mover - Example: Verifying the Failover Configuration - Teradata Data Mover
Teradata® Data Mover Installation, Configuration, and Upgrade Guide for Customers - 20.01
- Deployment
- VantageCloud
- VantageCore
- Edition
- Enterprise
- IntelliFlex
- Lake
- VMware
- Product
- Teradata Data Mover
- Release Number
- 20.01
- Published
- November 2023
- Language
- English (United States)
- Last Update
- 2023-12-05
- dita:mapPath
- jvt1700556161677.ditamap
- dita:ditavalPath
- stp1591127384938.ditaval
- dita:id
- pqq1467243714524
- Product Category
- Analytical Ecosystem
- On DM1, run datamove list_agents and verify that all three Data Mover agents (DM1, DM2, and DM3) are running.
- On DM2, run /etc/init.d/dmdaemon status and verify that the output indicates NOT RUNNING.
- On DM2, run /etc/init.d/tdmrest status and verify that the output is NOT RUNNING.
- On DM2, run /etc/init.d/tdactivemq status and verify that the output status is NOT RUNNING.
- Run a Data Mover TPT job.
- Set max_agents_per_task to the number of Data Mover agents in the cluster.
- Set data_streams to a value greater than or equal to max_agents_per_task.
- Check the job status to verify that the job ran successfully and that all Data Mover agents are in use.