The Data Mover Agent can be installed on a Linux Teradata server using the following procedure. You cannot use PUT to install or configure the Data Mover agent on a non-Teradata server, you must use dminstallupgradeagent.
- Enter ./dminstallupgradeagent at the command line to install the Data Mover agent and TTU packages.
- Answer the prompts as needed, press Enter to accept the defaults where appropriate.
- Enter rpm -qa |grep DMAgent to verify the installation.
- Follow the steps in Configuring ActiveMQ on Remote Agents if this is the first time installing or upgrading a standalone agent using this script.Once a standalone remote agent has been set up manually, the settings are preserved across upgrades.
**************************************************************************** * * * WARNING: A new activemq encrypted password has been generated. * * Any remote Agents that are connecting to activemq on * * this server must be updated as follows: * * * * 1) Copy /etc/opt/teradata/tdactivemq/datamover.properties from * * this server to the same location on the remote Agent host. * * * * 2) Set the permissions of this file on the remote Agent as: * * chmod 650 datamover.properties * * chgrp activemq datamover.properties * * * * 3) Update Agent broker.password property in agent.properties * * with the value defined in agent.properties on this server. * * * * Note: Update /etc/opt/teradata/datamover/agent.properties * * if this file exists, otherwise update * * /opt/teradata/client/nn.mm/datamover/agent/agent.properties * * (where nn.mm = version of Datamover). * * * * 4) Restart the Agent: * * /etc/init.d/dmagent stop * * /etc/init.d/dmagent start * * *