DSA Configurations | Teradata Data Mover - DSA Configurations - Teradata Data Mover

Teradata® Data Mover Installation, Configuration, and Upgrade Guide for Customers - 20.03
Deployment
VantageCloud
VantageCore
Edition
Enterprise
IntelliFlex
Lake
VMware
Product
Teradata Data Mover
Release Number
20.03
Published
July 2024
ft:locale
en-US
ft:lastEdition
2024-07-17
dita:mapPath
vuu1713418923137.ditamap
dita:ditavalPath
stp1591127384938.ditaval
dita:id
pqq1467243714524
Product Category
Analytical Ecosystem

There are three main supported configurations for running Data Mover DSA jobs:

Configuration 1: DSC Running on the Data Mover Server

Configuration 1 is the default setup when you do not have an existing DSA environment. The bundled DSC that comes with Data Mover is enabled for use.


Configuration 1: Example Data Mover system setup when using the bundled DSC.

See Configuring DSC to Run on the Data Mover Server for configuration instructions.

Configuration 2: Data Mover Using an External DSC

Use configuration 2 when you have an external DSC and one or more of your Teradata Data Mover source or target systems is running a version earlier than 16.00.


Configuration 2: Example diagram of Data Mover system set up when using an external DSC.

See Configuring Data Mover to Use an External DSC for configuration instructions.

Configuration 3: DSC Running on the Data Mover Server and Externally

Use configuration 3 when you have an external DSC and all your Teradata Data Mover source and target systems are version 16.00 and later. In this case, both the external DSC and the Data Mover bundled DSC can coexist.


Configuration 3: Example Data Mover system setup when using both the bundled and an external DSC.

See Configuring DSC to Run on the Data Mover Server and Externally for configuration instructions.