Refer to the following configuration steps when running DSA on both the Data Mover server and on an external server. To run DSA on the Data Mover server, you must have Data Mover 16.20 or later installed.
- For source and target TPA nodes with existing BAR NC ClientHandler software, edit the /etc/opt/teradata/dsa/clienthandler.properties and append the Data Mover host to broker.list as in the following example:
broker.list=153.64.24.162:61616,153.64.24.164:61616
- Register all source and target systems with DSC and restart DSMAIN.
- Install and configure BAR NC on new source or target TPA nodes.
- Configuring the Logical Netmask for ClientHandler.
- Enabling TLS 1.2 Data Path Encryption for DSC on the Data Mover Server