- Create a member JOBCARD in GTW.ESDLIB containing a valid z/OS JCL JOB card for your installation.The JOBCARD is automatically added to the customized job streams created in the next two steps.
- Edit the member #INSTCD in GTW.ESDLIB to customize all the values there for data set names and locations in the job stream customization process in the next step.Comments in the member are helpful.
- Make sure that all the following values are set as needed at this point since they are required to expand the GTW.ESDLIB and temporary ESD data sets in this procedure:
- GTW.ESDLIB ESD LIBRARY DSN
- ESDPFX ESD DATA SET NAMES PREFIX
- ESDU ESD DATA SETS UNIT
- ESDVOL ESD DATA SETS VOLSER
- TPFX HI-LEVEL QUALIFIER(S) (Max 35 Characters)
- TU DASD UNIT NAME (All Target Libraries)
- TVOL VOLSER FOR OTHER TARGET LIBS
- Create customized sample job streams in GTW.ESDLIB by running the following TSO command:EXEC 'fully-qualified-esdlib-dsn(#INSTXEC)'
- For a DASD installation, do not change the TVOLSER RELEASE TAPE VOLSER value using the following GTW.ESDLIB job BLDDA because it influences the intermediate DASD data set names.
- For a TTU z/OS tape installation, using the GTW.ESDLIB job BLDTP, set the TVOLSER RELEASE TAPE VOLSER value to the volume serial ID of the output tape.
The use of single quotes and the fully-qualified DSN is required so the TSO EXEC command will not append GTW.CLIST to the library name. - Examine the job streams in BLDEXP, PROCDA, BLDTP, and PROCTP members to make sure that they were customized correctly.These members create intermediate data sets on DASD or TAPE.
- [Optional] To re-customize these jobs, repeat steps 2-5, as needed.