Multiple DSA Network Client (ClientHandler) Instances | Teradata DSA - Multiple DSA Network Client (ClientHandler) Instances - BAR - Data Stream Architecture - Data Stream Extensions

Teradata® DSA - DSE for IBM Spectrum Protect Installation, Configuration, and Upgrade Guide

Deployment
VantageCloud
VantageCore
Edition
Enterprise
IntelliFlex
VMware
Product
BAR
Data Stream Architecture
Data Stream Extensions
Release Number
17.20
Published
November 2022
Language
English (United States)
Last Update
2023-08-18
dita:mapPath
txy1632417625021.ditamap
dita:ditavalPath
gjr1576617673366.ditaval
dita:id
B035-3155
Product Category
Software
Teradata Tools and Utilities

Configuring multiple DSA Network Client (ClientHandler) instances is required when there are two different networks at a site. Sometimes a site might have two private networks, or a public network and a private network.

For example, at a site where one media server is configured with a private network and a public network, in order to run a restore job using the public network, the private network IP addresses must not be used. In this situation, create two instances of DSA Network Client (ClientHandler) so that you can create two media servers in DSC. You can configure one of the media servers with addresses belonging to the public network, and one media server with addresses belonging to the private network. When a restore job must run on the public network, the media server configured with the public address is used instead of the media server with the private address.

You can also create a target group with the public media server and another target group with the private media server. If you create a Restore group between the private target group and the public target group, you can run a restore job using the Restore group over the public network.