Re-Enable Incremental Restore | Teradata DSA - Re-Enabling Incremental Restore - BAR - Data Stream Architecture

Teradata® DSA User Guide
Deployment
VantageCloud
VantageCore
Edition
Enterprise
IntelliFlex
VMware
Product
BAR
Data Stream Architecture
Release Number
17.20
Published
November 2022
Language
English (United States)
Last Update
2023-11-30
dita:mapPath
bis1632417576364.ditamap
dita:ditavalPath
vwp1576617377804.ditaval
dita:id
cyv1467242268519
Product Category
Software
Teradata Tools and Utilities
Use these instructions only to re-enable IR after it has been disabled. You cannot initially enable IR using these steps.
  1. Reset IR on the target system:
    [Command line] Run reset_ir_target_system.
    [BAR Setup portlet] Go to DSC Servers > Systems and Nodes > Systems > IR Support and click Reset.
  2. Create then run an IR restore job either as latest version (full) or with a specified version. Do not use next incremental restore.
    [Command line] Run create_job with enable_incremental_restore=true and next_incremental_restore=false.
    [BAR Operations portlet] Create an IR enabled restore job, and Edit the Source Save Set. Select either Latest version (Full) or Specify a version (Full)