AC Power - IntelliFlex Platforms - Teradata Vantage
Preparing Your Site For Teradata Vantage™ Hardware - 2.5
- Deployment
- VantageCore
- Edition
- IntelliFlex
- Product
- IntelliFlex Platforms
- Teradata Vantage
- Release Number
- 2.5
- Published
- March 2024
- ft:locale
- en-US
- ft:lastEdition
- 2024-04-26
- dita:mapPath
- ske1710762973120.ditamap
- dita:ditavalPath
- oqt1542232706976.ditaval
- dita:id
- gpk1556809249221
- Product Category
- Hardware
- Teradata Vantage
- The power on/off switches on rack chassis do not completely remove AC power. After shutting down and turning off a subsystem, the AC power cords must be unplugged from the chassis.
- Do not service a non-hot-pluggable component unless the power off procedure has been performed and the AC power cord has been unplugged from the chassis.
- The cabinet contains more than one AC power cord. To remove all power from the cabinet, you must disconnect all AC power cords from the site power source. Install the power outlets so they are near the equipment and easily accessible.
- Do not plug unauthorized equipment into the AC feeder box. The AC feeder box provides at least 200 volts which will damage 120 volt equipment.