Installing and Aligning Front and Rear Doors | Teradata Vantage - Installing and Aligning Front and Rear Doors - IntelliFlex Platforms - Teradata Vantage

Preparing Your Site For Teradata Vantageā„¢ Hardware - 2.5

Deployment
VantageCore
Edition
IntelliFlex
Product
IntelliFlex Platforms
Teradata Vantage
Release Number
2.5
Published
March 2024
Language
English (United States)
Last Update
2024-04-26
dita:mapPath
ske1710762973120.ditamap
dita:ditavalPath
oqt1542232706976.ditaval
dita:id
gpk1556809249221
Product Category
Hardware
Teradata Vantage
  1. Lift the door up and align the hinge receptacles with the hinge pins on the cabinet.
    The door is heavy and may require two people for installation.
  2. Drop the door into place.
    If the door hinges do not align correctly, you might need to loosen the hinges to adjust them.
  3. Adjust the door by slightly loosening the nuts that hold the hinge plate to the door.
    The hinge plate should only be able to move when pulled. There should be enough pressure from the nuts to create friction between hinge plate and door.
  4. Close the door and align the upper corners with either the cabinet side panels or the door corners of the cabinet ganged next to it.
    The door can be raised or lowered and canted at a slight angle.
  5. While holding the door in the desired position, open the door and tighten the nuts on the top hinge plate.
  6. Close the door to check alignment.
    If necessary, loosen the nuts slightly and adjust the door, then re-tighten the nuts.
  7. When the door is properly aligned, tighten all the nuts holding the hinge plates to the door.