Running the Controller Configuration Utility - Kubernetes

Kubernetes Appliance Software Installation Guide

Product
Kubernetes
Published
June 2018
Language
English (United States)
Last Update
2019-01-31
dita:mapPath
kpy1524680839041.ditamap
dita:ditavalPath
ft:empty
dita:id
kpy1524680839041
Product Category
Software
  1. Press Ctrl+Alt+Delete to reboot the node.
  2. When prompted, press Ctrl+R to run the Configuration Utility.
  3. If a Foreign View tab appears, delete it:
    1. In the Configuration Utility window, press Ctrl+N until the Foreign View tab is selected.
    2. Using the arrow keys, highlight Controller 0.
    3. Press F2 to open the Foreign Configuration box.
    4. Using the arrow keys, highlight Clear and press Enter.
    5. When notified that the foreign configuration will be lost, click OK and press Enter.
  4. In the Configuration Utility window, press Ctrl+N repeatedly to select the VD Mgmt tab.
  5. Using the arrow keys, select the top line, which starts at Intel ... then press F2 to select Create new VD.
  6. Set the RAID level on the second VD to RAID-5:
    1. Tab to RAID Level and press Enter.
    2. Select RAID-5 and press Enter.
  7. Tab to Physical Disks then press the space bar to select the following these disk check boxes: disk 2, disk 3, disk 4, and disk 5.
  8. Tab to Advanced and press Enter.
  9. Set the Write Policy:
    1. Tab to Write Policy and press Enter.
    2. Using the arrow keys, select Write Through and press Enter.
  10. Press Tab and the space bar to select Initialize.
  11. Tab to OK and press Enter.
  12. When informed that initialization will destroy data on the virtual disk, use the arrow keys to select OK and press Enter.
  13. Click OK twice and press Esc to exit.
  14. When prompted, tab to OK, press Enter, and press Ctrl+Alt+Delete to reboot the node.