Restart Services as Active | High Availability | Teradata Data Mover - Restarting Services - Teradata Data Mover

Teradata® Data Mover User Guide

Product
Teradata Data Mover
Release Number
17.10
Published
June 2021
Language
English (United States)
Last Update
2021-06-16
dita:mapPath
fcu1619423186706.ditamap
dita:ditavalPath
mpm1591127278842.ditaval
dita:id
B035-4101
lifecycle
previous
Product Category
Analytical Ecosystem
  1. From the designated-active or standby daemon server, run dmcluster status to verify the cluster state.
  2. Log on to the currently active daemon server and run the following:
    dmcluster setmaster

    The Data Mover components are restarted on the currently active server and stopped on the standby server. Sync monitor starts when the Data Mover cluster is in active mode.

    You can use the setmaster command any number of times without modifying the failover.properties file on the server.

  3. From the active daemon server, run dmcluster status to verify all services are running as expected.
    It may take a few minutes for all services to transition. Run dmcluster status as needed until the results are as expected. Monitor progress in dmFailover.log on the currently active daemon and monitor servers.
    If the Data Mover cluster is in standby mode, a failover has occurred. When the cluster is in standby mode, you can only restart services on the designated-standby daemon server. For more information about switching the Data Mover cluster back to active mode after a failover, see Failing Back to the Designated-Active Daemon