Use the stop command to stop a Data Mover job after the job has been started.
- Type datamove stop -job_name PayableJob1 on the command line, where PayableJob1 is the name of the job.The job status is set to USER CANCELLED. Agents are allowed to finish the job tasks already in progress, so that work on the job can continue after running the stop command. If the job was performing its final tasks, the job might complete. This allows the job to stop as cleanly as possible.
- Once the job has stopped do one of the following:
Option Description Clean up the job using the cleanup command. Release locks on the source and target system, and remove any temp tables or error tables (if created by the job). Start the job again from the beginning using the start command. Restarts the job.