Install Teradata Studio | Using the Command Line on Windows | Teradata Studio - 17.00 - Installing Teradata Studio Using the Command Line - Teradata Studio

Teradata® Studio™ and Studio™ Express Installation Guide

prodname
Teradata Studio
vrm_release
17.00
created_date
January 2021
category
Installation
featnum
B035-2037-129K
  1. Navigate to the directory where you downloaded the Teradata Studio package.
  2. Unzip the Teradata Studio package to your local file system.
  3. [Optional] Pre-configure connection profiles to assign at installation:
    1. In the unzipped Teradata Studio package, navigate to the Config directory.
    2. Edit the TeradataStudioDataSources_template.config file to define the connection profiles.
    3. Save the file as TeradataStudioDataSources.config in the Config directory or any other directory that is accessible by the installation process.
  4. [Optional] Pre-configure preferences to set at installation:
    If you edited and saved the TeradataStudioDataSources.config file to an alternate directory location in the previous step, then save the TeradataStudioPreferences.config file to this same location.
    1. In the unzipped Teradata Studio package, navigate to the Config directory.
    2. Edit the TeradataStudioPreferences_template.config file to define the preferences.
    3. Save the file as TeradataStudioPreferences.config in the Config directory or any other directory that is accessible by the installation process.
  5. [Optional] If you intend to connect to systems using Kerberos Authentication, create a krb5.ini file.
    This task is outside the scope of Teradata Studio.
  6. Run the Studio installer by typing setup.exe /s /v/qn /v"/l*v studio.log" followed by any or all of the following optional commands. Note that studio.log will contain a log file of the installation steps.
    1. [Optional] /v"CHECK_KERBEROS_FILE=1" /v"KERBEROS_FILE_PATH=\"C:\tmp\\"" to use Kerberos authentication.
      The KERBEROS_FILE_PATH must point to the directory containing your krb5.ini file.
    2. [Optional] /v"WORKSPACEPATH=\"C:\studio\WORKSPACEPATH\"" to use a workspace file location other than the default.
      The workspace directory contains workspace files, including the SQL project folder and log file.
    3. [Optional] /v"CHECK_PRECONFIG_FILE=1" /v"CONFIGFILE_PATH=\"C:\Temp\config files\"" to use specify the directory location of a pre-configured connection, which might include both profiles and preferences.
      When the path contains spaces, double quotes are required around the pathname.
  7. [Optional] If connecting to systems using Kerberos Authentication you must run kinit to initialize your Kerberos credential before launching Teradata Studio.