The SELECT command sets criteria determining the dump data selected for a load or unload operation.
Syntax
SELECT { ALL | ERROR | RESET | PROC nod-num [...] } [ ERRORDATE { 'yymmdd' | 'yyyymmdd' | "yymmdd" | "yyyymmdd" } ] ;
Syntax Elements
- ALL
- Load or unload operation select dump data from all processors. This is the default.
- ERROR
- RESET
- Load or unload operation.
- PROC nod-num
- Unload operation.
- yymmdd
- yyyymmdd
- Error date to be selected from the DBC.SW_EVENT_LOG table.
Usage Notes
You must always type the SELECT command before you type an UNLOAD command. If you do not specify a SELECT command, the entire dump is selected.
Negative processor numbers are used for special record types. When RESET is specified, dul retrieves dump data with negative processor numbers.
Example: Selecting dump data for load or unload
To select dump data, type the following:
select proc 16384;The following appears:
*** Processor selection set to list of processors.