This procedure describes how to enable Dynamic Host Configuration Protocol (DHCP) and verify that an IP address has been assigned to the tape library.
-
Log on to the Quantum Scalar Tape Library from the operator panel using the following credentials:
- User name: admin
- Password: password
- Select OK.
-
Under
, perform the following steps to set up DHCP:
- Tap IP version 4 to use IPv4 IP address formatting, then select Next.
- Tap Use DHCP to have an IP address automatically assigned to the system, then select Apply.
- If an additional screen appears, read the Caution statement, then select Apply. A Progress Window appears.
- When Success appears, select Close.
-
Verify an IP address has been assigned to the tape library.
- Verify the IP version 4 option button is activated, then select Next.
- Verify the IP address is displayed in the IP Address box.
- Select Cancel.