Configuring Viewpoint and BAR Setup - BAR - Data Stream Architecture - Data Stream Extensions

Teradata® DSA - DSE for Veritas NetBackup Installation, Configuration, and Upgrade Guide

Product
BAR
Data Stream Architecture
Data Stream Extensions
Release Number
16.20
Published
September 2019
Language
English (United States)
Last Update
2019-09-27
dita:mapPath
xyw1514490990327.ditamap
dita:ditavalPath
3151_DSE_ICUCustomer_1620_NetBackup.ditaval.ditaval
dita:id
B035-3151
lifecycle
previous
Product Category
Software
Teradata Tools and Utilities
You must enable and add BAR portlets to Teradata Viewpoint before you can configure the BAR portlets for running jobs.
  1. Enable BAR portlets for the role and for Viewpoint access. You can set BAR administrator privileges for any Viewpoint role in Roles Manager. You can set access to the portlet in Portlet Library.
  2. Add a Teradata system to Viewpoint portlets. You must add and enable a Teradata system in Monitored Systems to make it available in the BAR Setup, BAR Operations, and Viewpoint Monitoring portlets.
  3. Set up the systems and nodes from the BAR Setup portlet. Nodes are configured through autodiscovery. You can view the information but not edit it.
  4. Media servers are autopopulated with default BAR NC [DSA Network Client (ClientHandler)] port 15401 and IP address. Edit if needed.
  5. Configure a backup solution:
  6. Configure target groups for backup. The target groups must be mapped to the correct backup solutions.