Configure a System | Command Line | Teradata DSA - 17.20 - Configuring a System - BAR - Data Stream Architecture

Teradata® DSA User Guide

Data Stream Architecture
Release Number
November 2022
Last Update
Content Type
User Guide
Publication ID
English (United States)
Last Update
PrerequisiteBefore using this command, you must prepare an XML file that contains the necessary system configuration information, including the system name and limits on the number of streams per node. For more information, see config_systems.

The config_systems command configures the DSC settings for the Teradata system used for backup and restore jobs. It also sets the selector in the targeted system for ActiveMQ and establishes a JDBC connection to the target system. Nodes are configured automatically after restarting DSMain on the system.

Even though the repository backup system is already pre-configured, you must rerun config_systems to set up the system selector and AMP discovery before the system can be enabled for use.

  1. Type dsc config_systems followed by the parameters, and press Enter.
  2. Type the source user name and password, and press Enter.