Verify Route Changes | Teradata Data Mover - Verifying the Route Changes - Teradata Data Mover

Teradata® Data Mover Installation, Configuration, and Upgrade Guide for Customers

Product
Teradata Data Mover
Release Number
17.00
Published
November 30, 2021
Language
English (United States)
Last Update
2021-11-04
dita:mapPath
xmy1574692806525.ditamap
dita:ditavalPath
ffv1503415926374.ditaval
dita:id
B035-4102
lifecycle
previous
Product Category
Analytical Ecosystem
The new routes configured can be verified with the ip or netstat commands. Following are example outputs of these commands when the routes have been configured properly:
# ip route list
153.64.209.92 via 153.64.107.254 dev eth4
153.64.106.78 via 153.64.107.254 dev eth5
153.64.106.79 via 153.64.107.254 dev eth5
153.64.209.91 via 153.64.107.254 dev eth4
127.0.0.0/8 dev lo scope link
default via 153.64.107.254 dev eth2

# netstat -rn
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
153.64.209.92 153.64.107.254 255.255.255.255 UGH 0 0 0 eth4
153.64.106.78 153.64.107.254 255.255.255.255 UGH 0 0 0 eth5
153.64.106.79 153.64.107.254 255.255.255.255 UGH 0 0 0 eth5
153.64.209.91 153.64.107.254 255.255.255.255 UGH 0 0 0 eth4
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 153.64.107.254 0.0.0.0 UG 0 0 0 eth2