- Verify that all Data Mover agents are listed in the output on the original-active:
datamove list_agents
- Verify that the output is the same as in Step 1 on the designated-standby:
datamove list_agents
- Verify the daemon is not running on the designated-standby:
/etc/init.d/dmdaemon status
- Verify the REST service is not running on the designated-standby:
/etc/init.d/tdmrest status
- Verify the ActiveMQ is not running on the designated-standby:
/etc/init.d/tdactivemq status
- Run a Data Mover TPT job.
- Set max_agents_per_task to the number of Data Mover agents in the cluster.
- Set data_streams to a value greater than or equal to max_agents_per_task.
- Check the job status to verify that the job ran successfully and that all Data Mover agents are in use.