Before using this command, you must prepare
an XML file that contains the necessary system configuration information, including the
system name and limits on the number of streams per node. For more information, see
config_systems.
Setting
the stream limits to 0 for channel and standby nodes is not
needed.
The config_systems command configures the DSC settings for the Teradata system and nodes used for backup and restore jobs. It also sets the selector in the targeted system for ActiveMQ. Nodes are configured automatically after restarting DSMain on the system.
Even though the repository backup system is already pre-configured, you must rerun config_systems to set up the system selector and AMP discovery before the system can be enabled for use.
- Type dsc config_systems followed by the parameters, and press Enter.
- Type the source user name and password, and press Enter.