- Enter #ctl from the Linux prompt.
- Find (2) Start With Logons: All parameter from the >scr debug menu.
-
Enter at the prompt:
>2=dbc>write
-
The following message appears:
Control GDO was successfully written and you must perform a TPA reset.
-
Exit the menu.
>quit#tpareset -f now
-
Answer y to the prompt.
You can use pdestate -a to monitor the reset, this returns the message:
Only user DBC Logons are enabled.
- Repeat these steps to set the parameter back to All logons once the system seeding workflow is completed.