Configure Primary Group for Hive Users | Teradata Fabric - Configuring the Primary Group for Hive Users - Teradata Fabric

Teradata® Fabric - Installation and User Guide - 3.11
Product
Teradata Fabric
Release Number
3.11
Published
August 2026
ft:locale
en-US
ft:lastEdition
2026-08-15
dita:mapPath
svw1780362788070.ditamap
dita:ditavalPath
ezw1784752870623.ditaval
dita:id
lxg1591800469257
  1. Run one of the following commands on Linux to enable logging for the primary group of Hive users:
    Option Action
    Non-Kerberized CDH, CDP, or Dataproc. Change the primary group for the Hive user and enable logging using a Hive connector on a non-Kerberized Hadoop cluster.

    usermod -g hadoop hive

    Run the remaining commands on all nodes.
    Kerberized CDH, HDP, or Dataproc. Enable logging using a Hive connector on any Kerberized Hadoop cluster. Each user corresponding the a Kerberos principal must contain the primary group of hadoop.

    usermod -g hadoop principalName

    Run the remaining commands on all nodes.