Installing Standalone Cabinet Stabilizers - BAR Managed Servers - IntelliBase Platforms - IntelliFlex Platforms

Teradata® Hardware Site Preparation Guide

Product
BAR Managed Servers
IntelliBase Platforms
IntelliFlex Platforms
Published
October 2020
Language
English (United States)
Last Update
2020-10-26
dita:mapPath
fsf1526587780889.ditamap
dita:ditavalPath
exclude_all_interim_filters_FLUTO.ditaval.ditaval
dita:id
fsf1526587780889
Product Category
Hardware
You must install side stabilizers for standalone cabinet configurations. Stabilization is required to prevent tipping of the cabinet when a heavy component is extended.

The side stabilizer kit, 2021-K221, comes with a left and a right stabilizer and four bolts. The bracket for the stabilizers is incorporated in the front bottom rail of the cabinet.

  1. Align the cabinet so that the stabilizers will not block vented tiles.
  2. Place the left stabilizer on the floor at the left front of the cabinet.
  3. Slip the left stabilizer under the front lip of the cabinet cross member and adjust the leveling feet to align the bolt holes.
  4. Attach the left front stabilizer to the cabinet cross member, using two of the screws supplied in the kit.
  5. Repeat with the right stabilizer.
    Installing the Side Stabilizers
    Installing side stabilizers on a standalone cabinet