Install Teradata Studio | Using the Command Line on Windows | Teradata Studio - Installing Teradata Studio Using the Command Line - Teradata Studio

Teradata® Studio™ and Studio™ Express Installation Guide - 17.20
Product
Teradata Studio
Release Number
17.20
Published
September 2022
Language
English (United States)
Last Update
2022-09-23
dita:mapPath
ugy1648839236372.ditamap
dita:ditavalPath
ft:empty
dita:id
B035-2037
Product Category
Teradata Tools and Utilities
  1. Go to the directory where you downloaded the Teradata Studio package.
  2. Unzip the Teradata Studio package to your local file system.
  3. [Optional] Pre-configure connection profiles to assign at installation:
    1. In the unzipped Teradata Studio package, go to the Config directory.
    2. Edit the TeradataStudioDataSources_template.config file to define the connection profiles.
    3. Save the file as TeradataStudioDataSources.config in the Config directory or any other directory that is accessible by the installation process.
  4. [Optional] Pre-configure preferences to set at installation:
    If you edited and saved the TeradataStudioDataSources.config file to an alternate directory location in the previous step, then save the TeradataStudioPreferences.config file to this same location.
    1. In the unzipped Teradata Studio package, go to the Config directory.
    2. Edit the TeradataStudioPreferences_template.config file to define the preferences.
    3. Save the file as TeradataStudioPreferences.config in the Config directory or any other directory that is accessible by the installation process.
  5. [Optional] If you intend to connect to systems using Kerberos Authentication, create a krb5.ini file.
    This task is outside the scope of Teradata Studio.
  6. Type setup.exe /s /v/qn /v"/l*v studio.log" followed by any or all of the following optional commands and run the Studio installer. Note that studio.log contains a log file of the installation steps.
    1. [Optional] /v"CHECK_KERBEROS_FILE=1" /v"KERBEROS_FILE_PATH=\"C:\tmp\\"" to use Kerberos authentication.
      The KERBEROS_FILE_PATH must point to the directory containing your krb5.ini file.
    2. [Optional] /v"WORKSPACEPATH=\"C:\studio\WORKSPACEPATH\"" to use a workspace file location other than the default.
      The workspace directory contains workspace files, including the SQL project folder and log file.
    3. [Optional] /v"CHECK_PRECONFIG_FILE=1" /v"CONFIGFILE_PATH=\"C:\Temp\config files\"" to use specify the directory location of a pre-configured connection, which may include both profiles and preferences.
      When the path contains spaces, double quotes are required around the pathname.
  7. [Optional] If connecting to systems using Kerberos Authentication you must run kinit to initialize your Kerberos credential before launching Teradata Studio.