Install Teradata Studio | Using the Command Line on Windows | Teradata Studio - Installing Teradata Studio Using the Command Line - Teradata Studio

Teradata® Studio™ and Studio™ Express Installation Guide
Product
Teradata Studio
Release Number
20.00
Published
October 2023
ft:locale
en-US
ft:lastEdition
2026-07-20
dita:mapPath
auw1696897611677.ditamap
dita:ditavalPath
ft:empty
dita:id
ftk1467314950349
  1. Go to the directory where you downloaded the Teradata Studio package.
  2. Unzip the Teradata Studio package to your local file system.
  3. [Optional] Pre-configure connection profiles to assign at installation:
    1. In the unzipped Teradata Studio package, go to the Config directory.
    2. Edit the TeradataStudioDataSources_template.config file to define the connection profiles.
    3. Save the file as TeradataStudioDataSources.config in the Config directory or any other directory that is accessible by the installation process.
  4. [Optional] Pre-configure preferences to set at installation:
    1. In the unzipped Teradata Studio package, go to the Config directory.
    2. Edit the TeradataStudioPreferences_template.config file to define the preferences.
    3. Save the file as TeradataStudioPreferences.config in the Config directory or any other directory that is accessible by the installation process.
  5. [Optional] If you intend to connect to systems using Kerberos Authentication, create a krb5.ini file.
    This task is outside the scope of Teradata Studio.
  6. Type setup.exe /s /v/qn /v"/l*v studio.log" followed by any or all of the following optional commands and run the Studio installer. Note that studio.log contains a log file of the installation steps.
    1. [Optional] /v"CHECK_KERBEROS_FILE=1" /v"KERBEROS_FILE_PATH=\"C:\tmp\\"" to use Kerberos authentication.
      The KERBEROS_FILE_PATH must point to the directory containing your krb5.ini file.
    2. [Optional] /v"WORKSPACEPATH=\"C:\studio\WORKSPACEPATH\"" to use a workspace file location other than the default.
      The workspace directory contains workspace files, including the SQL project folder and log file.
    3. [Optional] /v"CHECK_PRECONFIG_FILE=1" /v"CONFIGFILE_PATH=\"C:\Temp\config files\"" to use specify the directory location of a pre-configured connection, which may include both profiles and preferences.
      When the path contains spaces, double quotes are required around the pathname.
    4. [Optional] /v"ENABLE_AI_ASSISTANT=1" to install the AI Assistantbeta feature. By default, the AI Assistantbeta feature is not installed during a silent/command-line installation. Set ENABLE_AI_ASSISTANT=1 to include it, or omit this parameter (or set ENABLE_AI_ASSISTANT=0) to exclude it.
  7. [Optional] If connecting to systems using Kerberos Authentication you must run kinit to initialize your Kerberos credential before launching Teradata Studio.