Alternatively, you can configure CMICs in batch mode.
-
From the Azure portal, note IP information as follows:
- For the CMIC VM, the public IP address
- For multi-node or single-node VMs, the private IP address of each database node
- For the Teradata Viewpoint VM and other managed VMs, such as Teradata Data Mover and Teradata Ecosystem Manager, the private IP address of each VM
-
Verify ports on the Vantage VM, Viewpoint VM, and all VMs to which Server Management is connecting are open to the private IP address of the Server Management node.
At a minimum, ports 5180-5181 and 5190-5191 should be open on the Vantage and all application VMs.
- Log on to the VM using the authentication type you chose when deploying the VM.
-
Run the configuration utility.
# sudo /opt/teradata/cmic/bin/cmic-cloud-config
-
When prompted, enter IP address information for each database node:
- For multi-node systems, enter the private IP addresses of each database node, enclosed in brackets and separating multiple values with a space:
Teradata DBS systems > [private-DBS-IP1 private-DBS-IP2]
- For single-node systems, enter the private IP address of the database node, without brackets:
Teradata DBS systems > private-DBS-IP
- For multi-node systems, enter the private IP addresses of each database node, enclosed in brackets and separating multiple values with a space:
-
When prompted, enter the private IP address of the Viewpoint VM.
Teradata Viewpoint IP > private-VP-IP -
When prompted, do one of the following:
- Enter the private IP addresses of all the managed VMs, such as Teradata Data Mover and Teradata Ecosystem Manager, separating the IP addresses with a space.
- Press Enter if you do not have any managed VMs to add.
The Vantage and Viewpoint private IP addresses are populated from the previous steps.All Managed instances > private-DBS-IP private-VP-IP private-DM-IP private-Eco-IP
-
[Enterprise, Advanced, Base tiers only] If you have a site ID, enter it.
SiteID > AZRTDBnnnnnnnnn -
If there is no configured Server Management administrator password, the utility prompts you to enter one.
ServerManagement admin password > PasswordThe password must be between 6-32 alphanumeric characters.The utility validates your entries. -
If there is no configured Server Management REST password, the utility prompts you to enter one.
ServerManagement REST password > passwordThe password must be between 6-32 alphanumeric characters.The password is required but will not be stored. -
When prompted, enter yes to continue which finishes the updates to the CMIC configuration.
Proceed with CMIC configuration? (yes/no) > yesAfter completing this procedure, you can configure the Server Management portlet on the Viewpoint server. See Teradata® Viewpoint User Guide.