Frequency - INPUT - Analysis Parameters - Teradata Warehouse Miner

Teradata® Warehouse Miner™ User Guide - Volume 1Introduction and Profiling
Product
Teradata Warehouse Miner
Release Number
5.4.6
Published
November 2018
ft:locale
en-US
ft:lastEdition
2018-12-07
dita:mapPath
rfc1538171534881.ditamap
dita:ditavalPath
ft:empty
dita:id
B035-2300
Product Category
Software
  1. On the Frequency dialog box, click on INPUT.
  2. Click on analysis parameters.
    Frequency > Input > Analysis Parameters

    This screen has the following options available:
    • Only include frequency values that occur a minimum percentage of the time
      • Minimum Percentage — If checked, this option will show frequency only for those values that occur in at least this percentage of rows. Enter an integer or decimal value between 0 and 100. The default value is 1.0 for 1 percent.
    • Include rank, cumulative count, and cumulative percent information for each frequency value
      • If checked, show these cumulative statistics for each frequency generated. This option is not available when the Frequency Style 'Pairwise' has been selected on the data selection tab.
    • Only include the top 'n' frequency values
      • Number of frequency values to include — If checked, show frequency only for the number of top occurring values entered. This option is enabled only if Include rank, cumulative count, and cumulative percent information … is selected above.