Configure the DSC for the Public Cloud Using the CLI | Teradata DSA - Configuring the DSC for the Public Cloud Using the CLI - BAR - Data Stream Architecture

Teradata® DSA User Guide
Product
BAR
Data Stream Architecture
Release Number
17.00
Published
August 2020
Language
English (United States)
Last Update
2020-08-31
dita:mapPath
mas1575933453856.ditamap
dita:ditavalPath
vwp1576617377804.ditaval
dita:id
B035-3150
lifecycle
previous
Product Category
Software
Teradata Tools and Utilities
CLI users can configure and use the DSC in the public cloud (AWS or Azure) by using the command line.
  1. In the cloud product, run dsu-init from the DSC master node.
    [AWS] See Initializing a DSC Instance, in the Teradata Vantage™ on AWS (DIY) Installation and Administration Guide, B035-2800.
    [Azure] See Initializing a DSC VM, in the Teradata Vantage™ on Azure (DIY) Installation and Administration Guide, B035-2810.
  2. In the cloud product, run barnc-init from each Teradata node.
    [AWS] See Configuring and Initializing ClientHandler on Vantage Nodes, in the Teradata Vantage™ on AWS (DIY) Installation and Administration Guide, B035-2800.
    [Azure] See Configuring and Initializing ClientHandler on Vantage Nodes, in the Teradata Vantage™ on Azure (DIY) Installation and Administration Guide, B035-2810.
  3. If you want to back up to the cloud from an on-premises system, you must install the AXMS3 or AXMAzure packages, see Teradata® DSA - DSU Installation, Configuration, and Upgrade Guide, B035-3153 for the instructions.
  4. Using the BAR CLI on the DSC master node, run the following commands:
    1. config_systems
    2. enable_component
    3. config_aws OR config_azure
  5. Create target groups. See Target Groups.
  6. Set up repository backup. See Backing Up the DSC Repository with the Command Line.
  7. Create and run jobs. See Planning a Job: Command Line.