15.00 - Chapter 2 Configuration Utility (config) - Teradata Database

Teradata Database Support Utilities

prodname
Teradata Database
vrm_release
15.00
category
Configuration
featnum
B035-1180-015K

The Configuration and Reconfiguration utilities, config and reconfig, are used to define the AMPs and PEs that operate together as a Teradata Database. (The Reconfiguration utility is described in Utilities Volume 2.)

Use Configuration to define the system: the interrelationships among the AMPs, AMP clusters (logical groupings of AMPs), PEs, and hosts that are connected as a Teradata Database system. (The Reconfiguration utility uses information from Configuration to configure the Teradata Database components into an operational system.) You must access a system console to use either utility.

Use the Configuration commands described in this chapter to add, delete, list, modify, move, or show AMPs and PEs. Other steps in configuring a system involve the Parallel Database Extensions (PDE) portions of Teradata Database, and are configured with the PUT utility.

For more information on PUT configuration steps, see the Parallel Upgrade Tool (PUT) Reference, available from http://tays.teradata.com/. After logging on to Teradata @ Your Service, click Support Information, then select Operating Systems & Hardware from the Support Document Content section to search for the document.

Scenarios Runs From

The Configuration utility runs from Database Window or comparable interface to the Teradata Database console subsystem, such as cnsterm.

For general information on starting the utilities from different interfaces, see Appendix B: “Starting the Utilities.”