15.00 - END CONFIG - Teradata Database

Teradata Database Support Utilities

prodname
Teradata Database
vrm_release
15.00
category
Configuration
featnum
B035-1180-015K

END CONFIG

Purpose  

The END CONFIG command validates and updates the new configuration map and terminates a configuration session.

Syntax  

Usage Notes  

When the END CONFIG command is executed, Configuration validates the new configuration map.

As a result, one of the these events can occur:

  • The session is terminated, the new configuration is accepted when the configuration changes are validated, and the new configuration map is updated on disk.
  • The system displays:

    The session is terminated and the new configuration is stored.

    The Teradata Database is ready for reconfiguration.

  • The END CONFIG command is ignored because one of the following occurred:
  • A BEGIN CONFIG command was not entered, and, therefore, no configuration session is in progress.
  • The Teradata Database has not completed startup.
  • The configuration changes were not valid; an error message that describes the problem is displayed.
  • When the END CONFIG command is not executed successfully, the system displays:

    The new configuration was not stored due to error(s) detected. Please update the configuration and try END CONFIG again.