15.11 - Configuring a System and Node - Data Stream Architecture

Teradata Data Stream Architecture (DSA) User Guide

prodname
Data Stream Architecture
vrm_release
15.11
created_date
December 2016
category
User Guide
featnum
B035-3150-026K
Before using this command, you must prepare an XML file that contains the necessary system and node configuration information, including the system name, node IP addresses, and limits on the number of streams per node. For more information, see config_systems.
Setting the stream limits to 0 for channel and standby nodes is not required.

The config_systems command configures the DSC settings for the Teradata system and nodes used for backup and restore jobs. It also sets the selector in the targeted system for ActiveMQ.

Even though the repository backup system is already pre-configured, you must rerun config_systems to set up the system selector and AMP discovery before the system can be enabled for use.

  1. Type dsc config_systems followed by the parameters, and press Enter.
  2. Type the source user name and password, and press Enter.