16.20 - Installing Teradata ActiveMQ - Data Stream Extensions

Teradata® DSA - DSE for Veritas NetBackup Installation, Configuration, and Upgrade Guide

prodname
BAR
Data Stream Architecture
Data Stream Extensions
vrm_release
16.20
created_date
September 2019
category
Configuration
Installation
featnum
B035-3151-127K
Install Teradata ActiveMQ on the DSC server. If Teradata JDK is not installed on the DSC server, install it first.
  1. [DSA 16.20.51 and earlier] Verify Teradata JDK 7.
    1. Check if Teradata JDK 7 is installed: rpm -q teradata-jdk7
    2. If necessary, install Teradata JDK 7 by extracting then running the script: tar -zxvf teradata-jdk7__slesxx_arch.xx.xx.xx.xx-######.tar.gz rpm -ivh teradata-jdk7__xx.xx.xx.xx-######-arch.rpm
  2. [DSA 16.20.51 and later with Teradata ActiveMQ 5.15.9] Verify Teradata JDK 8.
    1. Check if Teradata JDK 8 is installed: rpm -q teradata-jdk8
    2. If necessary, install Teradata JDK 8 by extracting then running the script: tar -zxvf teradata-jdk8__slesxx_arch.xx.xx.xx.xx-######.tar.gz rpm -ivh teradata-jdk8__xx.xx.xx.xx-######-arch.rpm
  3. Install Teradata ActiveMQ. rpm -ivh tdactivemq__slesxx_arch.xx.xx.xx.xx.rpm
  4. [Required] Configure Teradata ActiveMQ with the DSAPostAMQ script to optimize memory utilization:
    1. Extract the script: tar zxvf DSAPostAMQ_slesxx_arch.xx.xx.xx.xx-######.tar.gz
    2. Run the script: ./tdactivemq_wrapper.py