Verifying Failover Configuration - Teradata Data Mover

Teradata Data Mover Installation, Configuration, and Upgrade Guide for Customers

Product
Teradata Data Mover
Release Number
16.00
Published
December 2016
Language
English (United States)
Last Update
2018-03-29
dita:mapPath
fsa1467305282096.ditamap
dita:ditavalPath
ft:empty
dita:id
B035-4102
Product Category
Analytical Ecosystem
  1. Run datamove list_agents on the original-master and check that all Data Mover agents are listed in the output.
  2. Run datamove list_agents on the designated-slave and check that the output is the same as in Step 1.
  3. Run /etc/init.d/dmdaemon status on the designated-slave and make sure the daemon is not active.
  4. Run a Data Mover ARC job.
    1. Set max_agents_per_task to the number of Data Mover agents in the cluster.
    2. Set data_streams to a value greater than or equal to max_agents_per_task.
    3. Check the job status to verify that the job ran successfully and that all Data Mover agents are utilized.
  5. Run a Data Mover TPT job.
    1. Set max_agents_per_task to the number of Data Mover agents in the cluster.
    2. Set data_streams to a value greater than or equal to max_agents_per_task.
    3. Check the job status to verify that the job ran successfully and that all Data Mover agents are utilized.