Enable or add a DSC Server | DSA | DSE | DSU - 17.05 - Enabling or Adding a DSC Server - Data Stream Extensions

Teradata® DSA - DSE for IBM Spectrum Protect Installation, Configuration, and Upgrade Guide

prodname
BAR
Data Stream Architecture
Data Stream Extensions
vrm_release
17.05
created_date
September 2020
category
Configuration
Installation
featnum
B035-3155-090K
Use these instructions to enable or add an additional DSC. If you have a DSC and are upgrading or adding another DSC, use this procedure before upgrading.
  1. Open the BAR Setup portlet.
  2. Click "" next to DSC Servers.
  3. Under General System Details, enter the broker information:
    Option Description
    Broker IP/Host Hostname or IP address of the machine running the ActiveMQ broker (where tdactivemq is installed), usually the DSC server.
    Broker Port Port number on the server where the ActiveMQ broker is listening (61616 for tcp, 61617 for ssl). Default: 61616
    Broker Connectivity Type of ActiveMQ connection (tcp or ssl). If tcp is chosen, the ActiveMQ connection is validated during install. If ssl is chosen, the ActiveMQ (jms ssl) password should match the DSA REST API https password. Default: tcp
  4. Select Enable DSC server.
  5. Select the DSC Server.
    1. Click Discover Servers.
    2. Select the DSC Server Name from the drop-down.
    TroubleshootingIf the DSC names are not populated in the menu, check the following:
    • Verify that the Broker IP/Host is correct.
    • Make sure ActiveMQ is running:

      /etc/init.d/tdactivemq status

  6. Enter the Server Settings and BAR Logging settings:
    Option Description
    Security Management Require Teradata Viewpoint authentication on the DSA command-line interface. If checked, a user submitting certain commands from the command-line interface must enter a valid Teradata Viewpoint user name and password.
    BAR Logging Level of BAR log information to display for the Data Stream Controller and the BAR Network Client. Extensive logging information is typically only useful for support personnel when gathering information about a reported problem.
    Error
    Default. Enables minimal logging. Provides only error messages.
    Warning
    Adds warning messages to error message logging.
    Info
    Adds informational messages to warning and error message logging.
    Debug
    Full logging. All messages, including debug, are sent to the job log.
    This setting can affect performance.
    Delete Retired Jobs Delete Retired Jobs determines the time period before retired jobs are deleted.
    After
    Number of days from the date a job is retired to wait before deleting the job.
    Never
    Prevents deletion of retired jobs.
  7. Click Apply.