Before starting this procedure, do the following:
Your deployment site must have access to the web-based Teradata EMS server for this procedure. If your site cannot access the Internet, see Deploying Teradata Database on VMware for Sites without Internet Access.
- Open a VMware vSphere PowerCLI shell version 5.5 or later.
- Navigate to the directory containing the Teradata Database on VMware deployment executable file (C:\mylocation\Teradata_Deployer\).
- [Optional] For troubleshooting purposes, make copies of the common.IT.properties.json and node.IT.properties.json properties files, label them according to the system to be deployed, and then save them.
- Run tdc.deploy.exe, using the properties files originally used to deploy the VMs.
- At the prompt, type IP address or FQDN for your vCenter.
At the prompt, type deploy, and press Enter.
- Select the Common Properties file, and press Enter.
- Select the Node Properties file, and press Enter.
- If a message warns you that running scripts is disabled, you must set the execution privileges, then proceed to the next step. See PowerCLI Requirements.
- From the PowerCLI terminal, type deploy. For a description of the actions this state (command) performs, see PowerCLI Commands for Teradata Database on VMware.
Review the information and do one of the following:
- If it is correct, press y.
- If the information is incorrect, edit the properties files and re-run the deployment executable file.
If there are no errors, the VM deploys. The deployment executable file is re-entrant, meaning if errors occur, they can be fixed and the executable runs all states again. Action is only taken as needed.
After the VM deploys, complete the applicable procedures under Deployment Verification.