Stopping a Job - Teradata Data Mover

Teradata Data Mover User Guide

Product
Teradata Data Mover
Release Number
16.10
Published
June 2017
Language
English (United States)
Last Update
2018-03-29
dita:mapPath
kmo1482331935137.ditamap
dita:ditavalPath
ft:empty
dita:id
B035-4101
lifecycle
previous
Product Category
Analytical Ecosystem
After a Data Mover job has been started, you can stop it before it has completed by using the stop command.
  1. Type datamove stop -job_name PayableJob1 on the command line, where <PayableJob1> is the name of the job. The job status is set to USER CANCELLED. Agents are allowed to finish the job tasks already in progress, so that work on the job might continue after running the stop command. If the job was performing its final tasks, the job might complete. This allows the job to stop as cleanly as possible.
  2. Once the job has stopped do one of the following:
    Option Description
    Clean up the job using the cleanup command. Release locks on the source and target system, and remove any temp tables or error tables (if created by the job).
    Start the job again from the beginning using the start command. Restarts the job.