Setting SNMP Traps for the Scalar i6000 - BAR Tape Libraries

Quantum Scalar i80, i500, and i6000 Setup and Configuration Guide

Product
BAR Tape Libraries
Published
September 2015
Language
English (United States)
Last Update
2018-07-12
dita:mapPath
njd1470863805324.ditamap
dita:ditavalPath
qtm_i80_i500_i6000.ditaval.ditaval
dita:id
grs1470858707039
Product Category
Hardware
This procedure describes how to set up Simple Network Management Protocol (SNMP) Traps to acquire unsolicited SNMP messages from the tape library.
  1. Log on to the Quantum Scalar Tape Library from the operator panel using the following credentials:
    • User name: admin
    • Password: password
  2. Select OK.
  3. Under Setup > Notification > Trap Registration, perform the following steps to set up SNMP traps:
    1. In the New Registration section, tap in the Host/IP box, enter the CMIC IP address, then select OK.
      Contact the system administrator if you do not know the IP address of the SOV-enabled CMIC. Use the default UDP port of 162.
    2. Select Create. If changes were made, a Success window appears.
    3. Select OK, then Close.