This procedure describes how to set up Simple Network Management Protocol (SNMP) for remote monitoring and management of the tape library.
-
Log on to the Quantum Scalar Tape Library from the operator panel using the following credentials:
- User name: admin
- Password: password
-
Under
, select the following check boxes to set up SNMP:
- Network Interface
- SSH Services
- ICMP
- Remote UI
- SNMP
- SMI-S
- Select Apply.
- If changes were made, select Close in the Success window.
- If changes were not made, select Close, then Cancel.
-
Under
, perform the following steps to complete the SNMP set up:
- Scroll to Page 2.
-
Select the following check boxes:
- Enable SSL
- Enable SNMP V1/V2
- Enable SMI-S
- If selected, deselect the Disable Remote Service User and Enable IPv6 check boxes.
- Select Apply.
- If changes were made, select Close in the Success window.
- If changes were not made, select Close, then Cancel.