Installing Teradata Database for VMware for DSU Upgrade - BAR - Data Stream Architecture - Data Stream Utility

Teradata® DSA - DSU Installation, Configuration, and Upgrade Guide
Product
BAR
Data Stream Architecture
Data Stream Utility
Release Number
16.20
Published
September 2019
Language
English (United States)
Last Update
2019-09-27
dita:mapPath
cbv1514490990317.ditamap
dita:ditavalPath
3153_DSU_ICUCustomer_1620.ditaval.ditaval
dita:id
B035-3153
lifecycle
previous
Product Category
Software
Teradata Tools and Utilities
Make sure you have followed the instructions in Preparing the DSC Repository for Upgrade before starting this procedure.
  1. In the Properties directory, edit the properties file, dsu.IT.properties.json, to provide the following:
    • "vmName": "VMname from TVME14.10"
    • "public_ip": "ip_address from TVME14.10"
  2. Install Teradata Database for VMware using one of these methods:
  3. Check the version of the DSC to verify that it matches the version of the downloaded packages: rpm -q DSC
  4. If the version of the DSC is the same as the version you upgraded on TVME 14.10, skip this step. Otherwise upgrade the DSU software using the same downloaded packages you used on the TVME 14.10 VM. Install the new packages in this order:
    1. Upgrade the DSC. See Installing the DSC Package.
    2. Upgrade ClientHandler. See Installing the ClientHandler Package.
    3. Upgrade BARCmdline. See Installing the BARCmdline Package.
    4. Upgrade BARPortlets. See Installing the BARPortlets Package.
  5. Stop all DSA services.
  6. Make sure the 15.11.02 or later repository savesets from the preparing step are accessible to the new VM at the same location (under the same filepath for a file system target group).
  7. If the media server used to back up the savesets from the 15.11.02.xx DSC was installed on TVME 14.10 VM, change the name in the clienthandler.properties file.
    1. Edit /etc/opt/teradata/dsa/clienthandler.properties
    2. Change server.id=<MediaServerName from TVME 14.10>
  8. Run the following commands in BTEQ to drop the BAR and BARBACKUP databases: delete database BAR; drop database BAR; delete database BARBACKUP; drop database BARBACKUP;
  9. Run $DSA_DSC_Root/recoverDSCRepository.sh to recreate the DSC repository.
  10. Start all DSA services to re-establish connection to the DSC repository.
  11. Run DSAPostDeployer.
    1. Unzip and extract the file.
    2. Run modify_dsc_name.sh.
    3. Enter the hostname from TVME 14.10 when asked for the new DSC name.
  12. See Migrating the Data from TVME 14.10.