- Run the dbscontrol utility to verify that the MDS is Enabled flag is set.
When the MDS is Enabled flag is set in dbscontrol, the RSG starts automatically with the Teradata Database.
- Display the MDS is Enabled flag:
display general
On Linux, view the /var/log/messages file to see if RSG started.
On Windows, an entry that indicates RSG started is made in the Event Viewer log.
If DEBUGTRACE is set to ON, full RSG logging takes place.
If DEBUGTRACE is set to OFF, minimal logging occurs.
The REPLACE option indicates that the old RSG log file will be removed and a new log file created at the next TPA reset.
The files are located in the following directory:- tdconfig_directory\RSG (Windows)
- tdconfig_directory/RSG (Linux)
One set of files exists on each node.
- If the tdinfo utility
indicates that the RSG vproc is not online, run the vprocmanager
utility to set it online:
- set xxxx online
where xxxx is the ID of the RSG vproc on one TPA node.
The id of the RSG vproc on the RSG master node should be as follows:The id of the RSG vproc on secondary RSG nodes should be as follows:RSG Version id on the Master Node 13.10 or earlier 9215 14.0 or later 26623 RSG Version id on the Secondary Node 13.10 or earlier 9214 or a lesser number (9213, 9212, and so on) 14.0 or later 26622 or a lesser number (26621, 26620, and so on) Repeat these steps for the other TPA nodes.
The RSG stops when the Teradata Database stops.