TDP3621 "npname" "service/portinfo"
Explanation:
When STARTing an NP after specifying a TDP command CONFIG NP DATABASE value, an NP could not be acquired. The DETAIL operand was specified on the START command, and this is the third of four messages that provide detail about the problem. The CONFIG NP SERVICE and port information used for the acquisition are displayed, with the port information being one of the following: 'OVERRIDE PORT = number' if the CONFIG NP PORT value was used. 'DEFAULT PORT = number' if default port of 64432 was used. 'SERVICE = name' if either the CONFIG NP SERVICE value or its default value, 'ntcimast', was used. 'SERVICE = (UNKNOWN), DEFAULT PORT = number' if either the CONFIG NP SERVICE value or its default value, 'ntcimast', was not recognized by the network so the default port, 64432, was used.
Generated By:
TDP.
Notes:
If the acquisition request fails using multiple names, this message is displayed only the first time since the information is the same for all failures.
Remedy:
This message provides diagnostic information and does not indicate another error.